Done in
10 minutes.
Custom-cut for your car. No tools. No adhesive on glass. Pull it off in seconds when you need to.
Find your carPer window. No professional installer needed.
Wipe the window inside with the included alcohol pad. Wait 30 seconds for it to fully dry. This is the only step that matters — dirty glass = bubbles.
Pull the film off its backing. It's already cut to your exact window. Line up the edges, peel the tape liner along the edge, press the tape to the glass.
Smooth across the surface with the included squeegee from the centre outward. Done in under 10 minutes per window.
Need to pass inspection? Selling the car? Want a different shade?
Peel one corner, lift the entire film off in one piece, peel the tape from the edge. Zero residue on the glass. Total removal time per window: about ten seconds.
The film itself is reusable until it gets damaged. The tape strips are single-use — buy replacement strips from us anytime if you peel and re-install often.
No. Everything you need ships in the box — squeegee, alcohol pads, microfiber cloth, printed guide. The only thing to bring is your car.
Lift the film off and try again — the tape is forgiving for the first few attempts. If the tape stops sticking after multiple peels, message us — replacement tape strips are S$5 a set.
Avoid it. Heat softens the adhesive too quickly and the film tries to stick before you've aligned it. Install in a shaded carpark or early morning / evening. Indoor garage is ideal.
Small bubbles usually flatten within 24–48 hours as the tape settles. For bigger bubbles, peel the film back, wipe the glass with the alcohol pad again, and re-press from the centre out. If you can't get a clean install, email us a photo and we'll talk you through it — genuine manufacturing defects are covered for 7 days.
The film is designed for DIY — most people finish a Full Side Set in under an hour their first time. If you'd rather not, email us and we'll recommend an SG mobile installer (~S$80 flat fee).